How to Dye Fabric With Coffee

Using a Coffee Dye Bath

Prepare your fabric and brew your coffee. Before dyeing, wash and dry the fabric as you normally would. This removes any dirt and oil that could keep the dye from penetrating evenly. The amount of coffee that you should brew will depend on how dark you would like the fabric to be. Stronger coffee will achieve a darker tint. Newly purchased fabrics may be coated with a finishing spray, so it is especially important to follow through with this step. If you are looking to create a darker tint with the coffee, use more coffee or use a dark/very strong roast. If you would like a lighter tint, use less coffee or use coffee that is a light or medium roast. As an alternative to preparing several batches of coffee at home, you can use instant coffee or you can purchase brewed coffee from a local store or coffee shop. This could be significantly more expensive, however.

Fill a pot with water. Place the pot on the stove and turn the burner to high. The size of the pot will depend on how much fabric you are dyeing. As a rule of thumb, you will need a large enough pot to completely submerge the fabric in water.

Pour brewed coffee into the pot. When the coffee is finished brewing, pour the coffee into the pot with the water.

Bring the mixture to a boil. After pouring all of your prepared coffee into the pot, bring the coffee/water to a boil. Turn off the heat as soon as the coffee reaches a full boil.

Add the fabric to the pot. Once you have turned the heat off and the coffee has stopped bubbling, submerge the fabric entirely into the coffee. Stir it around a bit to make sure any air pockets are eliminated. Since the water just stopped boiling, it may be best to use a wooden spoon, so as not to burn yourself or ruin your utensils.

Steep the fabric. The longer your fabric steeps in the coffee, the deeper it will be dyed. You will need to wait about an hour for appreciable, colorfast results, but you can allow a longer steeping time for a deeper tint.

Remove and rinse the fabric. Remove the fabric from the coffee dye and rinse it thoroughly under cold water. Do this until the water runs clear, which will indicate that all of the excess dye has been removed. After rinsing the excess coffee dye, you will be able to accurately tell how dark the fabric has been tinted. If you still want the fabric to be darker after rinsing it, you can steep the fabric again. Once you have achieved the desired tint, prepare a large enough container to hold all of your fabric with cold water and let the fabric soak. You can add vinegar to this cold water bath and let soak for ten minutes to set the dye.

Rinse the pot. When you are finished dyeing the fabric, rinse the pot. The coffee dye may stain the pot if you do not drain and wash it promptly after the dyeing process is complete.

Wash and dry the fabric gently. Use a delicate cycle in the washing machine with cold water and use a mild detergent. You can then dry the fabric on low in the dryer or hang it up in the shade to dry. The coffee dye described above will not provide a completely colorfast finish since it is a natural dye, which means that the color will fade a bit with each successive wash.

Using a Coffee Rub

Wash your fabric and brew your coffee. Before dyeing, wash the fabric but do not dry it. This removes any dirt and oil that could keep the rub from penetrating evenly. You will need the used grounds of the coffee that is brewed. A good method to use for this is to use a French Press or use a coffee maker. You can wash the fabric with the rest of your clothes or just wash it by itself, depending on your preference. Be sure to follow the washing instructions of the fabric, if provided. You will need enough coffee grounds to cover the entirety of the fabric that you are dyeing. You may need to brew several pots of coffee for this purpose. Pick a dark roast to dye the fabric darker and a lighter roast if you do not wish for it to be very dark. This is a great way to make use of your used coffee grounds. If you are a regular coffee drinker, you can save the used coffee grounds for this method.

Create a paste with the used coffee grounds. Once the grounds have cooled, add the coffee grounds to a large bowl and then add water. You will need about a tablespoon of water per cup of grounds. Stir the water into the grounds with a wooden spoon so that the water has evenly penetrated the mix. It does not need to be a fine paste so stirring spoon 7-8 times should be enough.

Spread the paste onto the fabric. Lay the fabric to dry on a water-proof surface. Be sure to cover the fabric completely with the coffee grounds and rub the coffee into the fabric. This can be done with a wooden spoon or similar utensil, or you can use your hands for this part. This can be messy so you will want to do this somewhere where it is acceptable to make a mess, such as in a garage. You can also lay down plenty of newspaper to protect the floor or carpeting.

Dry the fabric. Hang the fabric up to air dry in a place that is shaded. You will want to wait for the fabric to dry completely. This may take anywhere from several hours to an entire day. You can also dry the fabric in the dryer on low heat for approximately thirty minutes. Do not let the fabric air dry in the sun because the sun will fade your fabric.

Brush off the coffee grounds. You can brush off the grounds with your hands, shake the grounds off by shaking out the fabric or use a brush with natural fibers to remove all of the grounds. If the fabric is still not dark enough, repeat the process until it is to your liking.

Press the fabric with an iron if desired. Using an iron will remove wrinkles from the fabric. The fabric will need to be completely dry for the best results with the hot iron.

Tie-Dyeing with Coffee

Wash your fabric and brew your coffee. Before dyeing, wash and dry the fabric as you normally would. This removes any dirt and oil that could keep the rub from penetrating evenly. The amount of coffee that you should brew will depend on how dark you would like the fabric to be. Stronger coffee will achieve a darker tint. You can wash the fabric with the rest of your clothes or just wash it by itself, depending on your preference. Be sure to follow the washing instructions of the fabric, if provided. If you are looking to create a darker tint with the coffee, use more coffee or use a dark/very strong roast. If you would like a lighter tint, use less coffee or use coffee that is a light or medium roast. As an alternative to preparing several batches of coffee at home, you can use instant coffee or you can purchase brewed coffee from a local store or coffee shop.

Let the coffee cool. You can put it in the refrigerator for about 20 minutes or simply wait for it to cool for a couple of hours at room temperature.

Pour the coffee into the squeeze bottles. This is so you can pour the dye onto the sections without spilling anything into other sections. Reserve different squeeze bottles for different types of roasts (i.e. one squeeze bottle with a dark roast, another bottle for a light roast).

Section off areas of the fabric. You can twist the fabric and use the rubber bands to section the areas. This will ensure that you know which sections should be dyed and will also prevent the dye from sinking too far into the fabric. Spread the fabric out completely. Take your finger, place it in the middle of the garment, and begin turning your finger and hand clockwise. The fabric will start to bunch up as you twist. Be sure to keep the fabric orderly and create a circular shape, like a very wide and short cylinder, similar to the shape of a pie. Once the fabric is shaped like a pie, rubber band it in sections as if you are dividing the pie into eighths.

Dye the sectioned areas with the coffee. Use the squeeze bottles to pour the coffee onto the fabric. You may want to use more or darker coffee on certain sections to create a color variance. Once you have finished dying the top part, flip it over and dye the bottom.

Place the fabric into a sealed container. Depending on the size of the fabric, you can use a plastic container or a ziplock bag. Seal the bag or container and place it somewhere warm for 24 hours. If you have a lot of fabric, you can use a plastic storage container. They vary in size from a shoebox-size to large enough to store kitchen appliances and other large items.

Rinse the fabric. Once the coffee dye and fabric have set, open the ziplock bag or the container and remove the fabric. Rinse well under cold water, until the water runs clear.